江蘇春晨電纜有限公司：http://www.wididy.cn/st82365/
Usage requirements of YH electric welder cable:YH電焊機電纜
(1)YH電纜是在低電壓(zui高電壓為200V)大電流的條件下工作,要求具有一定耐性。
(1) YH cable is working under the condition of low voltage (maximum voltage is 200V) big current, the requirement has certain patience.
(2)焊把線電纜*允許工作溫度不應超過65℃。YH電焊機電纜
(2) welding wire cable to allow the working temperature should not be more than 65.
(3)電機引接線電纜頻繁地移動，扭繞和施放,要求柔軟,彎曲性能好。
(3) the electric motor leads the connection cable to move frequently, twisted around and cast, the request is soft, the curving performance is good.
(4)在施放中易受到尖銳鋼鐵構件的刮、擦,故要求電纜絕緣抗撕、耐磨等機械性能好。
(4) in the release of sharp steel components are easy to be scraped, rub, it requires the cable insulation resistance to tear, wear resistance, good mechanical properties.
(5)使用環境條件復雜,如日曬、水沸、接觸泥水、機油、酸堿液體等,要求有一定的耐氣候性和耐油、耐溶劑性。
(5) the use of complex environmental conditions, such as sun, water boiling, water, oil, oil, acid and alkali liquid, etc., are required to have a certain weather resistance and oil resistance, solvent resistance.
(6)有時會碰到熱焊件,要求耐熱變形性好。
(6) sometimes it can be met with hot welding parts, heat resistance is good.
(7)經常移動,要求外徑小,重量輕。由于對此種電纜電性能要求不高,且使用環境條件復雜,在結構上要求滿足各種復雜的環境因素是不適宜的。使用時注意改善使用條件,防止外來破壞。
(7) often moving, the outer diameter is small, the weight is light. Because the electrical performance of the cable is not high, and the use of the environment is complex, it is not suitable for the structural requirements to meet the various complex environmental factors. Attention to use conditions to improve the use of conditions to prevent external damage.
Electric welding machine cable [1] (YH cable) full name high strength rubber sheath electric welding machine cable, commonly known as the welding line, is a YC cable (general rubber sheathed cable). For the electric welding machine two secondary side wiring and electrode holder, welding connection cable, its characteristic is high, low voltage resistance. Operating voltage is generally 450V to 750V.
The structure of electric welding machine cable for a single core, usually with copper wire conductor composed of groups, groups of copper group is composed of welding cable, so YH cable body coarse copper wire, hundreds of root. Many groups around the copper wire by a layer of heat-resistant polyester film wrapped insulation. The insulating layer is pure natural rubber, copper wire for copper, so, in order to ensure the safety of wire and cable of good conductivity.
