收購|銷售|R&S?FSMR 測量接收機
R&S?FSMR 測量接收機兼具多臺儀器的功能，采用特殊設計，可以處理信號發生器和固定式或可調式衰減器校準相關的測量任務。
主要特點
? 頻率范圍：20 Hz～3/26.5/43/50 GHz
? 具有很高精度的寬電平測量范圍：+30dBm～–140dBm
? 高精度電平校準
R&S®FSMR 測量接收機兼具多臺儀器的功能，采用特殊設計，可以處理信號發生器和固定式或可調式衰減器校準相關的測量任務。
主要特點
• 頻率范圍：20 Hz～3/26.5/43/50 GHz
主要特點
• 頻率范圍：20 Hz～3/26.5/43/50 GHz
• 具有很高精度的寬電平測量范圍：+30dBm～–140dBm
• 高精度電平校準
• 調制度分析儀
• 調制度分析儀
• 具有THD和SINAD測量功能的音頻分析儀
• 可以連接R&S®NRP-Zxx 系列功率探頭的功率計主機
• 高性能頻譜分析儀
型號
| 名稱 | 訂貨號 |
| R&S®FSMR3測量接收機，20Hz到3.6GHz | 1313.9200.03 |
| R&S®FSMR26測量接收機，20Hz到26.5GHz | 1313.9200.26 |
| R&S®FSMR43測量接收機，20Hz到43GHz | 1313.9200.43 |
| R&S®FSMR50測量接收機，20Hz到50GHz | 1313.9200.50 |
主要特點
電平校準 – 精確、可重復和易于操作
• 優異的線性度和電平穩定度
• 允許高容差的頻率漂移和剩余調頻
• 可在很寬電平范圍內進行簡便的電平校準
直接連接功率傳感器以進行精確的功率測量
• 集成式功率分配器的功率傳感器模塊
• 可通過前面板按鍵（或通過IEC/IEEE總線、LAN口）操控儀器的所有功能（包括功率計）
• 支持多種功率計
• VSWR自動校正功能
簡便的調制和音頻分析
• 以 < 1 % 的測量不確定性測量調制深度、頻偏和相位偏移
• 調制頻率、THD和SINAD等音頻參數的自動分析測量
• 可分別在頻域和時域顯示音頻信號和解調信號
• 用于校準調制源的音頻輸入
多用途、高性能頻譜分析儀
• 功能全面的頻譜分析儀
• 齊全的檢波器
• 多種類型的分辨率濾波器和較大的帶寬
• 全面的分析功能
| Hardware Options | |||
|---|---|---|---|
| YIG Preselection, 3.6 GHz to 26.5 GHz not with | 1157.1903.26 | ||
| YIG Preselection 3.6 GHz to 26 GHz not with | 1157.1903.43 | ||
| YIG Preselection with 20 dB Preamplifier, 3.6 GHz to 26.5 GHz not with | 1157.1955.26 | ||
| YIG Preselection 3.6 GHz to 50 GHz for FSMR 50 for | 1157.1903.50 | ||
| OCXO, low aging/improved phase noise at 10 Hz carrier offset | 1144.9000.02 | ||
| Tracking generator 100 kHz to 3.6 GHz | 1142.8994.02 | ||
| Output Attenuator, 0 dB to 70 dB requires | 1142.9349.02 | ||
| Removable Hard Disk | 1303.0400.14 | ||
| Second Hard Disk for FSMR-B18 requires | 1303.0600.04 | ||
| RF Preamplifier 3.6 GHz to 26 GHz for R&S FSMR 26 requires | 1157.0907.05 | ||
| Vector signal analysis for FSMR 28 MHz demodulation bandwidth, demodulation hardware included | 1169.5696.02 | ||
| 30 dB Preamplifier, 100 kHz to 50 GHz only for not with | 1157.2100.50 | ||
| Electronic Attenuator, 0 dB to 30 dB, and 20 dB Preamplifier （3.6 GHz） not with | 1144.9298.02 | ||
| Attenuation Calibration Kit | 1169.4954.02 | ||
| N-type Adapter for | 1417.0909.02 | ||
| Software Options | |||
| VOR/ILS Measurement Demodulator for | 1302.0936.02 | ||
| Application Firmware for Noise Figure and Gain Measurements for Outperforming any conventional noise measurement system | 1300.6508.02 | ||
| Application Firmware for Phase Noise Measurement | 1161.8138.02 | ||
| GSM/EDGE Application Firmware | 1141.1496.02 | ||
| 3GPP BTS/Node B FDD Application Firmware 3GPP transmitter measurements with | 1154.7000.02 | ||
| 3GPP UE FDD Application Firmware 3GPP transmitter measurements with | 1154.7252.02 | ||
| 3GPP HSDPA BTS Application Firmware （requires 3GPP transmitter measurements with Requires | 1300.7156.02 | ||
| 3GPP TD-SCDMA BTS Application Firmware Base station and station tests on TD-SCDMA with the | 1300.7291.02 | ||
| 3GPP TD-SCDMA UE Application Firmware Base station and station tests on TD-SCDMA with the | 1300.8100.02 | ||
| CDMA2000® / IS-95 （cdmaOne） / 1xEV-DV BTS | 1157.2316.02 | ||
| CDMA2000®/1xEV-DV MS Application Firmware | 1157.2416.02 | ||
| CDMA2000®/1xEV-DO BTS Application Firmware Transmitter measurement on 3GPP2 signals with Signal Analyzer | 1157.2851.02 | ||
| CDMA2000®/1xEV-DO MS Application Firmware Transmitter measurement on 3GPP2 signals with Signal Analyzer | 1300.6689.02 | ||
